AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Norseman wood heater manual12/7/2022 NOTE: Do NOT break off jumper for low voltage.Wont be suggesting this wood Compare Review Summary Build Quality 2.6 ( 5 ) Value for Money 2.2 ( 5 ) Noise Level 2.2 ( 5 ) Heating Speed 3.4 ( 5 ) Temperature Consistency 2.8 ( 5 ) Safety 4.5 ( 4 ) Masport R1500 4.3 from 12 reviews Latest review: We have a Masport Belvedere wood heater, it was in the house when we bought it.Īll pretty good, but we needed one for a new project, which is a HUGE open area, so after re Compare Review Summary Build Quality 3.8 ( 12 ) Value for Money 3.6 ( 11 ) Noise Level 3.6 ( 12 ) Heating Speed 3.9 ( 8 ) Temperature Consistency 3.9 ( 8 ) Safety 4.3 ( 10 ) Scandia Heat and Cook 3.4 from 19 reviews Latest review: We didnt want to spend 4 grand on a nectre heateroven and opted for the scandia, half the price of the nectre Has not disappointed at all Even while nobody recommended them.Įasy to use, heats Compare Review Summary Build Quality 3.2 ( 9 ) Value for Money 3.3 ( 10 ) Noise Level 4.1 ( 8 ) Heating Speed 3.0 ( 5 ) Temperature Consistency 2.6 ( 7 ) Safety 2.6 ( 8 ) Jindara Kimberley 3.2 from 10 reviews Latest review: We have had this heater for 4 years, and have tried properly dried wood from three different regions of SA. For parallel installations, install (two) 8˝ anti-back- QUALIFIED HEATING EQUIPMENT INSTALLER draft butterfly dampers (Vogelzang Model AD-8, not (one who is engaged in, and is responsible for, or is included with the furnace) in the heat (duct) pipes thoroughly familiar with the installation and operation a minimum of 18 inches above the furnace of gas, oil, and solid fuel burning heating appliances. FURNACE INSTALLATION NOTE: INSTALLATION MUST BE MADE BY A 6. ASSEMBLY INSTRUCTIONS Yo u r N O R S E M A N ™ Wa r m A i r F u r n a c e requires the following items to be assembled or installed by the furnace installer: Feed Door Pull Handle/Thermostat Assembly Feed Door Locking Handle Blower(s) and Blower Control. SLIDE FIREBRICKS TOWARDS REAR SO NO GAPS REMAIN BETWEEN BRICKS. OTHER COMBUSTIBLE MATERI- ALS OUTSIDE OF CLEARANCE DIMENSIONS MARKED ON FURNACE. LOCATING FURNACE continued WARNING: RISK OF FIRE DO NOT STORE FUEL, FLAM- MABLE LIQUIDS OR OTHER COMBUSTIBLE MATERIALS TOO CLOSE TO THE UNIT.
0 Comments
Read More
Leave a Reply. |